Yellow level: 2.6”(66mm) from tank top.
Red level: 1”(26mm) from tank top.
Cable tail: 2Ft(61mm) long, 22AWG PVC covered, terminated with 0.25” quick connect terminals.
Distance to controller: 100Ft(30m).

Sensor

Material: stainless steel, epoxy sealed.
Hole size: 3/8”(9.5mm).
Maximum panel thickness: 0.45”(11.5mm)
Splash proof sealing: Neoprene O ring.
Cable tail: 2Ft.(61mm), terminated with
0.25” quick connect terminals.

LED Lamps

Power: 12Volt at less than 1mA in standby, 40mA when lamps are on. Reverse polarity protected. Not fused.
Connections: 0.25” spade terminals.
Dimension: L 3”(77mm), H 1.5”(38mm), W 2”(51mm).
Install: any orientation with two #8 panhead screws.
Operating temp.:-4°F(-20°C) to 122°F(50°C).

Lamp Controller

When you begin fueling, turn on TankFull. TankFull will be active and waiting to sense and display the fuel level.

When the fuel level reaches to within 2.6” from the top of the tank the Yellow LED lamp is lit. When the fuel level reaches to within 1” from the top of the tank the Red LED lamp is lit.

The viewing angle of the LED lamps is approximately 45°. This gives you about 1.5Ft. left and right, when you are 3Ft in front of the LED.

Operation